Here is an exersize that involved fitting a set of springs to the loading ramps.
Included are some helpfull tables and a video or two that guides one through the prosses.
This would reduce the weight of the rampsand make it easier to lift when they are on the ground.
This is a popular conversion here in Australia, especially on trailers and horse floats.
Step on is to work out what type and how strong the spring must be.
The following tables can help.
So we start off with removing the existing ramps.
The bolts that kept the ramps to the load tray need to be replaced with a 20 mm steel bar
This picture shows what we need to accomplish.
New eyes need to be welded on the loading ramps with a 20 mm hole for the rod that
makes the hinge to pass through,
The spring in place to calculate the position of the small leg of the spring.
Checking out the clearance of the loading ramp and the hinge.
Nathan making the final welds and adjustment to the ramp.
One side all welded together and ready for a coat of paint.
Nathan screws the number plate back on and the job is almost done!
Job painted and completed.
Check out the video below that runs you through the step.
